Instructions for Lithium Battery TX Charging/Handling Principles

 Caution!!!

    Only use HT100 series battery charger for charging these Lithium batteries. Using any other charger will void the warranty and may cause the battery harm!

 Directions on use -

      HT100 & HT110 Plug charger into charging jack for minimum of 2-3hrs, if battery is only slightly used, charge time will be less. It’s ok to let charge over-night. Lithium batteries have no memory, so you can charge them as often as you like. You can monitor the charging process looking at the led on the charger red is charging, green is done. 

     HT150 Balance Charger - Plug balance charge plug into correct port on charger. Set current adjust at 1C ie, HT200 1A, HT220 1.5A, HT300 series 1A, HT500 2A. Corresponding lights will turn red. When all lights are green, charge is done.

Caution!!!!

      Do not let the battery voltage drop below 3V per cell, if you do, the battery may not be able to be recharged. This is a characteristic of Lithium batteries. The TX pack is considered dead under 10V. Most radio systems will start beeping at the lower 9V areas. If you are racing and the radio starts beeping, you have less than a minute to change/charge your battery or your radio will shut off. When the battery reaches 9.8V and lower it will dump very fast (in seconds). Therefore it is recommended to charge the battery before then.

      The more often you charge the battery, the more cycles/life you will get. It is recommended that you charge once per race day or weekend.

      This is a very simple battery/charging setup and if used properly and not abused you will get hundreds of charge cycles.

      If you have any problems or questions please call or email me. Thanks for Purchasing an HTBatteries product.